Benutzer-Werkzeuge

Webseiten-Werkzeuge


contiki:a-n-solutions-module:atany24001-usb-gateway:contiki-conf.h
/*
 * Copyright (c) 2006, Technical University of Munich
 * All rights reserved.
 *
 * Redistribution and use in source and binary forms, with or without
 * modification, are permitted provided that the following conditions
 * are met:
 * 1. Redistributions of source code must retain the above copyright
 *    notice, this list of conditions and the following disclaimer.
 * 2. Redistributions in binary form must reproduce the above copyright
 *    notice, this list of conditions and the following disclaimer in the
 *    documentation and/or other materials provided with the distribution.
 * 3. Neither the name of the Institute nor the names of its contributors
 *    may be used to endorse or promote products derived from this software
 *    without specific prior written permission.
 *
 * THIS SOFTWARE IS PROVIDED BY THE INSTITUTE AND CONTRIBUTORS ``AS IS'' AND
 * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
 * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
 * ARE DISCLAIMED.  IN NO EVENT SHALL THE INSTITUTE OR CONTRIBUTORS BE LIABLE
 * FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
 * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
 * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
 * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
 * LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
 * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
 * SUCH DAMAGE.
 *
 * This file is part of the Contiki operating system.
 *
 * @(#)$$
 */
 
/**
 * \file
 *         Configuration for AVR Zigbit Contiki kernel
 *
 * \author
 *         Simon Barner <[email protected]>
 */
 
#ifndef __CONTIKI_CONF_H__
#define __CONTIKI_CONF_H__
 
/*sz*/
#ifdef PROJECT_CONF_H
#include "project-conf.h"
#endif
/*sz*/
 
/* Platform name, type, and MCU clock rate */
#define PLATFORM_NAME  "Zigbit"
#define PLATFORM_TYPE  ZIGBIT
#ifndef F_CPU
#define F_CPU          8000000UL
#endif
 
#include <stdint.h>
 
/* The AVR tick interrupt usually is done with an 8 bit counter around 128 Hz.
 * 125 Hz needs slightly more overhead during the interrupt, as does a 32 bit
 * clock_time_t.
 */
/* Clock ticks per second */
#define CLOCK_CONF_SECOND 125
#if 1
/* 16 bit counter overflows every ~10 minutes */
typedef unsigned short clock_time_t;
#define CLOCK_LT(a,b)  ((signed short)((a)-(b)) < 0)
#define INFINITE_TIME 0xffff
#define RIME_CONF_BROADCAST_ANNOUNCEMENT_MAX_TIME INFINITE_TIME/CLOCK_CONF_SECOND /* Default uses 600 */
#define COLLECT_CONF_BROADCAST_ANNOUNCEMENT_MAX_TIME INFINITE_TIME/CLOCK_CONF_SECOND /* Default uses 600 */
#else
typedef unsigned long clock_time_t;
#define CLOCK_LT(a,b)  ((signed long)((a)-(b)) < 0)
#define INFINITE_TIME 0xfffffff0
#endif
/* These routines are not part of the contiki core but can be enabled in cpu/avr/clock.c */
void clock_delay_msec(uint16_t howlong);
void clock_adjust_ticks(clock_time_t howmany);
 
 
/* COM port to be used for SLIP connection */
/*sz*/
//#define SLIP_PORT RS232_PORT_0
#define SLIP_PORT RS232_PORT_1
/*sz*/
 
 
/* Pre-allocated memory for loadable modules heap space (in bytes)*/
#define MMEM_CONF_SIZE 256
 
/* Use the following address for code received via the codeprop
 * facility
 */
#define EEPROMFS_ADDR_CODEPROP 0x8000
 
#define CCIF
#define CLIF
 
#define RIMEADDR_CONF_SIZE       8
#define PACKETBUF_CONF_HDR_SIZE    0
 
//define UIP_CONF_IPV6            1 //Let the makefile do this, allows hello-world to compile
#if UIP_CONF_IPV6
#define UIP_CONF_ICMP6           1
#define UIP_CONF_UDP             1
#define UIP_CONF_TCP             1
#endif
 
/* The new NETSTACK interface requires RF230BB */
#if RF230BB
#define SICSLOWPAN_CONF_COMPRESSION       SICSLOWPAN_COMPRESSION_HC06
#define SICSLOWPAN_CONF_CONVENTIONAL_MAC  1     //for barebones driver, sicslowpan calls radio->read function
#undef PACKETBUF_CONF_HDR_SIZE                  //RF230BB takes the packetbuf default for header size
#define UIP_CONF_LLH_LEN         0
 
/* No radio cycling */
#if UIP_CONF_IPV6
#define NETSTACK_CONF_NETWORK     sicslowpan_driver
#else
#define NETSTACK_CONF_NETWORK     rime_driver
#endif
#define NETSTACK_CONF_MAC         nullmac_driver
#define NETSTACK_CONF_RDC         sicslowmac_driver
#define NETSTACK_CONF_FRAMER      framer_802154
#define NETSTACK_CONF_RADIO       rf230_driver
#define CHANNEL_802_15_4          26
#define RF230_CONF_AUTOACK        1
#define RF230_CONF_AUTORETRIES    2
#define SICSLOWPAN_CONF_FRAG      1
//Most browsers reissue GETs after 3 seconds which stops frag reassembly, longer MAXAGE does no good
#define SICSLOWPAN_CONF_MAXAGE    3
#define QUEUEBUF_CONF_NUM         1
#define QUEUEBUF_CONF_REF_NUM     1
/* Default uip_aligned_buf and sicslowpan_aligned_buf sizes of 1280 overflows RAM */
#define UIP_CONF_BUFFER_SIZE	240
 
#else
/* Original combined RF230/mac code will not compile with current contiki stack */
//#define PACKETBUF_CONF_HDR_SIZE    0            //RF230 handles headers internally
/* 0 for IPv6, or 1 for HC1, 2 for HC01 */
#define SICSLOWPAN_CONF_COMPRESSION_IPV6 0 
#define SICSLOWPAN_CONF_COMPRESSION_HC1  1 
#define SICSLOWPAN_CONF_COMPRESSION_HC01 2       //NB '2' is now HC06 in the core mac!
//FTH081105
#define SICSLOWPAN_CONF_COMPRESSION       SICSLOWPAN_CONF_COMPRESSION_HC01 
#define SICSLOWPAN_CONF_MAXAGE 5
#define UIP_CONF_LLH_LEN         14
#endif /*RF230BB */
 
#define SICSLOWPAN_CONF_MAX_ADDR_CONTEXTS 2
#define SICSLOWPAN_CONF_FRAG              1 
 
#define UIP_CONF_LL_802154       1 
 
#define UIP_CONF_MAX_CONNECTIONS 2
#define UIP_CONF_MAX_LISTENPORTS 2
#define UIP_CONF_UDP_CONNS       2
 
#define UIP_CONF_IP_FORWARD      0
#define UIP_CONF_FWCACHE_SIZE    0
 
#define UIP_CONF_IPV6_CHECKS     1
#define UIP_CONF_IPV6_QUEUE_PKT  0 
#define UIP_CONF_IPV6_REASSEMBLY 0
#define UIP_CONF_NETIF_MAX_ADDRESSES  3
#define UIP_CONF_ND6_MAX_PREFIXES     3
#define UIP_CONF_ND6_MAX_NEIGHBORS    4  
#define UIP_CONF_ND6_MAX_DEFROUTERS   2
#define UIP_CONF_UDP_CHECKSUMS   1
#define UIP_CONF_TCP_SPLIT       1
 
/*sz*/
/* ************************************************************************** */
//#pragma mark RPL Settings
/* ************************************************************************** */
#if UIP_CONF_IPV6_RPL
 
#define UIP_CONF_ROUTER                 1
#define UIP_CONF_ND6_SEND_RA		    0
#define UIP_CONF_ND6_REACHABLE_TIME     600000
#define UIP_CONF_ND6_RETRANS_TIMER      10000
/* For slow slip connections, to prevent buffer overruns */
//#define UIP_CONF_RECEIVE_WINDOW 300
#undef UIP_CONF_FWCACHE_SIZE
#define UIP_CONF_FWCACHE_SIZE    30
#define UIP_CONF_BROADCAST       1
#define UIP_ARCH_IPCHKSUM        1
#define UIP_CONF_PINGADDRCONF    0
#define UIP_CONF_LOGGING         0
//#define UIP_CONF_DS6_ROUTE_INFORMATION 0
#endif /* RPL */
/*sz*/
 
/* These names are deprecated, use C99 names. */
/*
typedef unsigned char u8_t;
typedef unsigned short u16_t;
typedef unsigned long u32_t;
typedef int32_t s32_t;
*/
typedef unsigned short uip_stats_t;
typedef unsigned long off_t;
 
 
#endif /* __CONTIKI_CONF_H__ */
Diese Website verwendet Cookies. Durch die Nutzung der Website stimmen Sie dem Speichern von Cookies auf Ihrem Computer zu. Außerdem bestätigen Sie, dass Sie unsere Datenschutzbestimmungen gelesen und verstanden haben. Wenn Sie nicht einverstanden sind, verlassen Sie die Website.Weitere Information
contiki/a-n-solutions-module/atany24001-usb-gateway/contiki-conf.h.txt · Zuletzt geändert: 2017/01/24 18:49 von 127.0.0.1