IPv6 Interface-Konfiguration anzeigen:

 netsh interface ipv6 show addresses   

http://windowsitpro.com/networking/q-when-i-add-static-ip-route-what-value-do-i-use-interface

Windows XP bildet die Interface-ID der IPv6 Adresse basierend auf dem modifizierten EUI-64 Verfahren. Ab Windows Vista wird dazu ein sogenannter „permanant“ randomized identifier verwendet, d.h. die IPv6-Adresse ist nicht mehr direkt aus der MAC-Adresse abgeleitet.

• http://download.microsoft.com/download/e/9/b/e9bd20d3-cc8d-4162-aa60-3aa3abc2b2e9/ipv6.doc
• http://technet.microsoft.com/en-us/magazine/2007.08.cableguy.aspx
• https://sid-500.com/2018/02/07/ipv6-how-windows-generates-link-local-addresses-eui-64/

Dieses Verhalten kann per netsh-Befehl abgeschalten werden:

netsh interface ipv6 set global randomize­identifiers=disabled  

netsh interface ipv6 add address InterfaceNameOrIndex IPv6Address [[type=]unicast|anycast]
 [[validlifetime=]Minutes|infinite] [[preferredlifetime=]Minutes|infinite] 
 [[store=]active|persistent]

Beispiel:

netsh interface ipv6 set interface InterfaceNameOrIndex [forwarding=]enabled|disabled] 
 [[advertise=]enabled|disabled] [[mtu=]MTUSize] [[store=]active|persistent]

netsh interface ipv6 add route IPv6Address/PrefixLength InterfaceNameOrIndex 
 [[nexthop=]IPv6Address] [[publish=]no|age|yes] [[validlifetime=]Minutes|infinite]
 [[preferredlifetime=]Minutes|infinite] [[store=]active|persistent]

netsh interface ipv6 add route fec0:0:0:1::/64 "Local Area Connection" publish=yes 
netsh interface ipv6 add route fec0:0:0:2::/64 "Local Area Connection 2" publish=yes

netsh interface ipv6 add route ::/0 "Local Area Connection 3" nexthop=fe80::2aa:ff:fe98:2ab1 
  publish=yes

C:>netsh interface ipv6 show /?

The following commands are available:

show address             - Shows IPv6 addresses.
show bindingcacheentries - Shows binding cache entries.
show destinationcache    - Shows destination cache entries.
show dns                 - Displays the DNS server addresses.
show global              - Shows global configuration parameters.
show interface           - Shows interface parameters.
show joins               - Shows IPv6 multicast addresses.
show mobility            - Shows mobility configuration parameters.
show neighbors           - Shows neighbor cache entries.
show prefixpolicy        - Shows prefix policy entries.
show privacy             - Shows privacy configuration parameters.
show routes              - Shows route table entries.
show siteprefixes        - Shows site prefix table entries.
show state               - Shows the state of deprecated functionality.
show teredo              - Shows Teredo service state.

• Microsoft Cable Guy
• Windows Kommandozeilen-Befehle
• Unidentified Networks - Set as Private or Public

!!! Teredo sendet nur dann IPv6 Pakete, wenn das Ziel ausschließlich über IPv6 erreichbar ist (DNS-Antwort). Bei Dual-Stack angebundenen Hosts wird immer IPv4 verwendet.

Status anzeigen lassen:

 netsh interface ipv6 show teredo

Teredo in Netzen mit Microsoft Active Directory aktivieren:

 netsh interface ipv6 set teredo enterpriseclient

Teredo deaktivieren:

 netsh interface ipv6 set teredo disable